Community Forums
Results 1 to 2 of 2

Thread: Installer User Interface Mode Not Supported after convert v6.1 project to v2010

  1. #1
    Join Date
    Nov 2013
    Posts
    19

    Installer User Interface Mode Not Supported after convert v6.1 project to v2010

    Hello:

    Help needed on following please.

    After conversion of an InstallAnywhere 6.1 Enterprise, Build 2325 project to: InstallAnywhere 2010 Enterprise, Build 3890, i get the following error when installing:

    (I am installing on Windows 10 machine)

    ChooseBundledVMs: Unable to locate the VMPack Directory

    =======================================================
    Installer User Interface Mode Not Supported

    The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The valid UI modes identifiers are GUI, Console, and Silent.


    My original installer binary (ie:InstallAnywhere 6.1 Enterprise, Build 2325) installs with no issues on Windows 10.
    The installer binary from project converted to InstallAnywhere 2010 Enterprise, Build 3890 gives above error on installation on Windows 10
    however if i install from command line with: <installerbinary> -i GUI I do not get above error!!
    So it looks like it is a conversion bug.

  2. #2
    Join Date
    Jul 2018
    Posts
    2

    This Link Will Help

    I got this link from Microsoft support community and I guess this might help you: https://answers.microsoft.com/en-us/...3-2f37e3ddca81

    Do see the comment section, you might get lot of info from it.

    With Regards,
    Xovo Larjem
    Tutuapp Kodi Showbox
    Last edited by wovolarjem; 07-31-2018 at 01:00 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •