PDA

View Full Version : launch executable



Lisa Yang
07-24-2002, 03:37 PM
My install (standard project) need launch a small executable, which shared some components with the install program.

If I set up to launch it after moving data, there is no problem.
I would like to launch it before moving data. In case something goes wrong, it is easy to rollback.

My question is all of components needed by this executable is not there yet. I can put them into set up files which could be accessed through SUPPORTDIR.

Is there any other way to do it? Any suggestion??

Thanks

RobertDickau
07-26-2002, 09:13 AM
As far as I know, there's no simple way to extract a file from your installation's cabinet files, so using Setup Files/SUPPORTDIR is probably the easiest way.