PDA

View Full Version : Custom Install Types



NewsArchive
08-15-1996, 12:00 AM
Hi,
I'm working on a project where I would like for the users to be able
to choose from one of the following three install types:
1. Install to Network
2. Network User Install
3. Stand-alone Install

I'm using InstallShield Express (16-bit target). Is there any way to
change the set-up type names to correspond with what I have above? If
not, does anyone have any ideas for a work-around?

Thanks,
Lance C. Leverich
lancel@realworks.com

NewsArchive
09-17-1996, 12:00 AM
> Lance Leverich <lleveric@realworks.com> wrote in article
<32137227.53BA@realworks.com>...
> Hi,
> I'm working on a project where I would like for the users to be able
> to choose from one of the following three install types:
> 1. Install to Network
> 2. Network User Install
> 3. Stand-alone Install
>
> I'm using InstallShield Express (16-bit target). Is there any way to
> change the set-up type names to correspond with what I have above? If
> not, does anyone have any ideas for a work-around?
>
> Thanks,
> Lance C. Leverich

> lancel@realworks.com
> //
>>Lance,
You cannot change the default Setup Type names. If you wish to have
this functionality
you will need to use InstallShield 3.

InstallShield Technical Support
Stephen