PDA

View Full Version : Billboards



NewsArchive
09-13-1996, 12:00 AM
I'm evaluating Express Pro and can't seem to get billboards to work. I
created 16-bit BMPs as specified by the help file, specified the
directory where those images were stored, and created my disk images.
If I go to a clean system and perform an install, the program installs
fine, but I never see a single billboard. I'm doing a 32-bit install.
Any suggestions? Thanks.


Cary D. Beuershausen
Systems Engineer
Advanced Data Systems
caryb@jax.jaxnet.com
http://www.jaxnet.com/~caryb

"Life would be much easier if I had the source code."

-----BEGIN PGP PUBLIC KEY BLOCK-----
Version: 2.6.2

mQBtAzGVBMoAAAEDAJnjNIoAJyFKabsIWBrGRFXDBqZf4PD0eI6krUbd24DN0Htc
Q/c/DrlUVMw/18QlcWtgVpiiN00p3JZZdAm5AbyOOrzlAga9ZyYu4tRvyyNE5gTW
OCnVbhsyZ0oK8D45QQAFEbQrQ2FyeSBELiBCZXVlcnNoYXVzZW4gPGNhcnliQGph
eC5qYXhuZXQuY29tPg==
=fxAe
-----END PGP PUBLIC KEY BLOCK-----

NewsArchive
09-16-1996, 12:00 AM
Cary D. Beuershausen <caryb@jax.jaxnet.com> wrote
> I'm evaluating Express Pro and can't seem to get billboards to work. I
> created 16-bit BMPs as specified by the help file, specified the
> directory where those images were stored, and created my disk images.
> If I go to a clean system and perform an install, the program installs
> fine, but I never see a single billboard. I'm doing a 32-bit install.
> Any suggestions? Thanks.

Have you read the Express Knowledge Base article X1027: Displaying Multiple
Billboards in Your Setup?

Ritesh