PDA

View Full Version : FlexNet embedded + VxWorks and x86 processor



PaolaHexMet
09-09-2015, 07:58 AM
Hello,

I am a firmware developer and new to this Community.

I am involved in a project for introducing a licensing management system on board of a numerical controller and I am trying to find out if FlexNet Embedded is the product which could do. My question is very preliminary:

the controller runs a firmware written in C++, based on vxWorks 5 (soon vxWorks 6) and a x86-32 processor. Is Flexera compatible with this configuration?

Thank you and regards.

P.S: I wrote to Flexera "Contact us" twice, but so far I got no answer.