PDA

View Full Version : Why the custom code panel in post-install is loaded before the installer start?



Carolwu
05-07-2015, 03:17 AM
In my post-install section, there is a custom code panel, in which I read the $CHOSEN_FEATURE_LIST$, but the value will always be the default value no matter how it was changed during pre-install.
Then I tried to use a variable that was not defined by default. Every time when the installer is launched, there will be an exception saying that this variable is missing and crash before even the introduction is shown.

Carolwu
05-07-2015, 03:44 AM
And I tried to move this panel to pre-install, everything was good.