PDA

View Full Version : Eligibility Conditions not working in a suite project



djm263
11-26-2012, 04:57 AM
Hello,
I built a fairly simple suite to try out eligibility conditions. I included 2 MSI files in my suite package and named one 64b and the other 32b for the platform they refer to.

Both these MSI's contain two simple text files with different names so i can figure out if the correct files were installed by the installer.I set the Architecture in the Platform Eligibility Condition to x86 for the 32bit component and x64 for the 64bit component, however, when i build and run the setup, it installed both the 32bit and the 64bit files on the 64bit machine and the installation "encountered an error" while installing on the 32 bit machine(it did deploy the 32bit files though).
Has anyone else faced the same problem?

djm263
11-27-2012, 04:33 AM
this works out if i create the suite and have two features with a component each for each feature, but i dont think that should be the way it should work because even if there is one feature which has two different platform dependent components, it should work.