PDA

View Full Version : WM5 Shortcut Not Added



arpitman
05-07-2007, 10:23 AM
I have an install that just contains a smart device installation. I have a version of my program (single EXE) that is for Pocket PC 2003 and one that is WM5. I also have a single shortcut to it.

I place the program in the \Windows folder because it is also used for a notification event. Install Shield creates 2 CAB files. One for 420 and one for 500.

The problem I have is that the short cut is not created on the WM5 installer. If I run the 420 CAB on my WM5 device the shortcut shows up fine. If I run the 500 CAB on the same device the program is installed ok, but the short cut does not show up.

I have checked the settings in the shortcut to make sure that the device type is checked and it is.

I have tried this on 2 different WM5 devices with the same results.

Any ideas?