PDA

View Full Version : Changing multiple component destinations



rpreston
08-24-2005, 04:18 PM
I'm exporting components from multiple installs into one combined install. I finally found out how to export all of the components from a feature into the new install. Then I'm associating the components with the feature in the new install. That's all failrly fast and simple to do but the destination has changed for the components and so far I haven't found a way to change the destination except by changing it for each component and there are a lot of them.

Any ideas?

Thanks,
Richard

RobertDickau
08-24-2005, 09:13 PM
Depending on what you're doing, you might use find-and-replace in the Direct Editor view, or use the InstallShield Automation interface...