PDA

View Full Version : WindowCE object in Modify Mode



DLee65
07-12-2005, 10:14 AM
I have a project that is using the WindowsCE object to install files to WinCE devices.

In MAINTENANCE, Modify mode - no matter which feature is selected, the WindowsCE object always installs again. I have a request to stop this from happening - but I am not able to figure out why this is happening.

In debug mode there is no idication that the feature is being reinstalled again, at least in the events that I have customized and have visible within the InstallShield IDE.

I have looked at this problem in DevStudio, IS 10, 10.5 and 11 without finding a method to stop this. I was looking for some type of similar action to ShowObjWizardPages that perhaps I could only execute in repair mode.

Thanks.