PDA

View Full Version : Upgrade problems Version 9 to Version 11



bobmcm
07-05-2005, 05:00 PM
I am trying to upgrade a version 9 project to Version 11. I finally got everything to build with no errors, but when I try an run I find many of the files are Read Only. This causes problems trying to read the my databases. I have rebuilt after making sure that all the files are read/write, but after the install, the files are still read only. How can I tell IS that these files need to be read/write.

Note: I would contact support, but the support website is so screwed up. I followed the instructions that were sent to me via email about the change, but it will not allow me to login, and will not allow me to create an account with my email as it says that I have an account with that email address already.

Robert McMahan
Futuresoft, Inc.

m.rudolph
07-06-2005, 08:09 AM
Perhaps you could force them to normal using:

SetFileInfo ( szPathFile, nType, nAttribute, szValue );

Using FILE_ATTR_NORMAL for nAttribute.

The help index has an example you can look at that may help if you search on SetFileInfo.

Best,

Mike