PDA

View Full Version : User defined function parameters not shown



Bobtcny
06-09-2005, 03:18 PM
I am evaluating IS 11. Have been using IS 6.31. I noticed something when I upgraded a 6.3 install to 11. In 6.31, when you call a user defined function, the parameter variables were show after typing the (, so that you would know what the function was looking for. I don't see this in 11. It is there for the IS functions, but not for the functions I created. Anyone else see this? If this is the way IS 11 handles user functions, it is not an improvement over 6.3.

icfantv
06-10-2005, 08:51 AM
I haven't used IS6.x since 2000 and I can't speak from experience, but are your functions prototyped correctly? I know that in order to make them "visible" to the custom actions section you have to follow an explicit export syntax.

I don't use IS 11, but just a thought.

-adam