PDA

View Full Version : Control Panel/Software hangs after repairing the installation



Buildmaster
04-30-2004, 08:21 AM
Hi everybody!

My installation works fine if I start it via setup.exe. When I use the control panel to repair or modify my installation, the control panel/software window hangs after the installation has finished.

I made a test where I removed all my script code - the control panel/software window doesn´t response after the installation has terminated. So I think it´s not my script code.

Can anyone help me?

Regards,
Buildmaster

Buildmaster
05-04-2004, 02:51 AM
After a few tests I found out, that the problem is caused by two programs which become started at the end of of my installation.
These programs will also start after a modify/repair of the installation. If I don´t start them, everything works.
When starting the installation with setup.exe there is no problem.

So I have another question now:
Can my installation detect that it has been started by control panel/software?

Regards,
Buildmaster