View Full Version : strange behavior of install sequence and CA

11-24-2003, 07:30 PM

I write a script in installshield and mke CA from it.
then i insert this CA into installation sequence. i set it's condition to 1 so it runs.

but this is not executed during install time. first installation does not execute this all all. but installation calls this CA when i try to remove program.

it was working fine before. and now, it is acting abnormally. how can i clear this mess??

thank you,

11-25-2003, 12:27 PM
What project type are you using? Basic MSI or Standard project?

It will allow others to provide more substantial help if you can provide your CA's attributes.