Creating RAS and TCP/IP installation in NT4.0

[NewsArchive]

Hi there!

I have to write a setup application for an ISP so I have to "silently"
install an entry in WindowNT 4.0's Remote Access Service and the TCP/IP
protocol. Is there a good function to do so?

Thank's for your patience...


Thomas Berglund
teb@algonet.se

Algonet/Telenordia Internet Staff
Tel. +46(8)58758700 Fax. +46(8)58758730

[NewsArchive]

Hi Thomas,
InstallShield does not have any functions which can do the silent
installation. I think you can write your own dll to do this. InstallShield
should support protocols. I do not have any examples to show this right
now.

Regards,
Keshav
Aditi Corp.

InstallShield Corporation Authorized Solution Provider

Aditi Corp was formerly known as NetQuest Inc.

Berglund <teb@algonet.se> wrote in article <33089563.7CBF@algonet.se>...
> Hi there!
>
> I have to write a setup application for an ISP so I have to "silently"
> install an entry in WindowNT 4.0's Remote Access Service and the TCP/IP
> protocol. Is there a good function to do so?
>
> Thank's for your patience...
>
>
> Thomas Berglund
> teb@algonet.se
>
> Algonet/Telenordia Internet Staff
> Tel. +46(8)58758700 Fax. +46(8)58758730
>

[NewsArchive]

Hi Thomas,
InstallShield does not have any functions which can do the silent
installation. I think you can write your own dll to do this. InstallShield
should support protocols. I do not have any examples to show this right
now.

Regards,
Keshav
Aditi Corp.

InstallShield Corporation Authorized Solution Provider

Aditi Corp was formerly known as NetQuest Inc.

Berglund <teb@algonet.se> wrote in article <33089563.7CBF@algonet.se>...
> Hi there!
>
> I have to write a setup application for an ISP so I have to "silently"
> install an entry in WindowNT 4.0's Remote Access Service and the TCP/IP
> protocol. Is there a good function to do so?
>
> Thank's for your patience...
>
>
> Thomas Berglund
> teb@algonet.se
>
> Algonet/Telenordia Internet Staff
> Tel. +46(8)58758700 Fax. +46(8)58758730
>

[NewsArchive]

Hi Thomas,
InstallShield does not have any functions which can do the silent
installation. I think you can write your own dll to do this. InstallShield
should support protocols. I do not have any examples to show this right
now.

Regards,
Keshav
Aditi Corp.

InstallShield Corporation Authorized Solution Provider

Aditi Corp was formerly known as NetQuest Inc.

Berglund <teb@algonet.se> wrote in article <33089563.7CBF@algonet.se>...
> Hi there!
>
> I have to write a setup application for an ISP so I have to "silently"
> install an entry in WindowNT 4.0's Remote Access Service and the TCP/IP
> protocol. Is there a good function to do so?
>
> Thank's for your patience...
>
>
> Thomas Berglund
> teb@algonet.se
>
> Algonet/Telenordia Internet Staff
> Tel. +46(8)58758700 Fax. +46(8)58758730
>